Someone saw “water” in the description

I think you’re missing a bottle of lube

brain empty of thoughts

mouth full of cock

he really just like me fr fr

You should, it’s never been better. I don’t play it as much as I should.

I sure don’t miss having to move the stupid jumpers for master/slave drives and then losing one of the bastards and having to try and jam a paperclip alongside the pins with some scotch tape to insulate it. Cable select was always a lie.

This gives me Warframe Corpus faction vibes…

Not even good soup. Real soups use some kind of broth to give a lot of base flavor.

Probably a bit of the board being averse to a low volume halo product, and a bit of the fact that Ford basically sold every single vehicle it made in the 80s and 90s and factory space was at a premium. Setting aside factory volume to squeeze in a 10k-per-year special model was not that attractive. Too small to dedicate its own factory to (like the Explorer), too big to not interfere with existing operations.

They also mention the heavy reliance on imported European parts and engineering, and I imagine that was a bit of a corporate negative at the time.

The unnamed International transmission in my dad’s old dump truck has reverse completely to the left and down. Conveniently placing it right in the middle of your goddamn leg.

It might not have been located quite that far over when new but now you basically have to scooch over and hug the driver door whenever you’re backing up at all.

Honorable mention to the 6sp ZF trans in my dad’s F550 flatbed, where reverse is left-and-up, also putting it near your knees and also in nice range of the hanging keys out of the ignition to whack against it randomly.

The chess square is not aligned with the monitor pixels so it is sharp edged on the bottom and left, but has a blended border on the top and right.

You’re welcome.

We are all the sons of someone’s crotch

Adapter or caddy is fine. Can get them on most shopping sites for cheap.

IIRC from my old office PC slinging days, a lot of those cases with 5-1/4 bays usually had slots for mounting screws that would allow you to mount a 3.5 drive flush to one sideusijg 2 screws. Then you get 1-3/4" 6-32 screw stand offs, thread it into the drive, and use that to mount it to the other side of the 5-1/4 bay.

Did that a lot to really old reused cases where there were a ton of 5-1/4 bays but only one 3.5 bay.

all in on two pair

Stack the jeans

Nah, they’ll make corporations immune from it but the normal consumer will still have to deal with licensing hell

Might be 6’3 if he was stretched out on one of those Medieval torture racks.

Pants pulled up high enough to cover the line of the adult diaper tapes.

you’re in it right now

Numbers like that should have been why you kept going in mech E.

Once you get past the educational stage, every one of those calculations becomes “OK now round to the closest whole number that gives you the larger factor of safety and move on”

Honestly that’s a complaint I have about nearly every pencil, not just the zebra. They’re almost always hard and smudgy because the pencil has been sitting out either in a warehouse or on an office supply shelf for like 5 years.
I’d rather bring my own hi-poly brick eraser, or even better, a hi-poly retractable eraser that is a lot easier to control and keep a fresh, smudge-free surface on.

#8 all the way.

If I had to do sketch design drafting in college with a pen or wooden pencil and not a 0.5 mechanical, I would have probably become a school shooter.